Power Setup
The Power Setup screen is used to configure battery parameters and also provide advanced settings for propellers.
Battery Voltage/Current Calibration
Enter data for your battery/power module from its data sheet: number of cells, full voltage per cell, empty voltage per cell. If provided, also enter voltage divider and amps-per-volt information.
QGroundControl can be used to calculate appropriate voltage divider and amps-per-volt values from measurements:
- Measure the voltage from the battery using a multimeter.
- Click Calculate next to the Voltage divider field. On the prompt that appears:
- Enter the measured voltage.
- Click Calculate to generate a new voltage-divider value.
- Click Close to save the value into the main form.
- Measure the current from the battery.
- Click Calculate next to the Amps per volt field. On the prompt that appears:
- Enter the measured current.
- Click Calculate to generate a new amps per volt value.
- Click Close to save the value into the main form.
Advanced Power Settings
Click the Show Advanced Settings checkbox to specify advanced power settings.
Voltage Drop on Full Load
Batteries show less voltage at high throttle. Enter the difference in Volts between idle throttle and full throttle, divided by the number of battery cells. The default value should be used if unsure!
WARNING
If the value is too high the battery may be deep-discharged and damaged.
ESC PWM Minimum and Maximum Calibration
To calibrate the ESC max/min PWM values:
- Remove the propellers.
- Connect the vehicle to QGC via USB (only).
- Click the Calibrate button.
WARNING
Never attempt ESC calibration with props on.
Motors should not spin during ESC calibration. However if an ESC doesn't properly support/detect the calibration sequence then it will respond to the PWM input by running the motor at maximum speed.
Other Settings
Select the Show UAVCAN Settings checkbox to access additional settings for UAVCAN Bus Configuration and motor index and direction assignment.